Primers

Swimming pool store, swimming pool parts, spa parts, spa chemicals, spa repair, swimming pool chemicals, swimming pool repair, swimming pool filters, swimming pool pumps, bioguard, hayward, pentair, sta-rite, jacuuzi, swimming pool motor, dimension one, waterway, aquaflo, polaris, kreepy krauly, letro, tigershark, swimming pool lights, swimming pool heater, swimming pool toys, swimming pool cleaners, swimming pool inflatables, retail  12001 Dorsett Road Maryland Heights, MO 63043 St. Louis Metro St. Louis, St. Charles, St. Louis County, St. Charles county, Saint louis, saint louis county, saint charles county, west county

Home When you are done with the rest, call THE BEST.

R & S Pool & Spa  

12001 Dorsett Road  

Maryland Heights, MO 63043

314-209-0770


HOURS:

Mon-Fri 9-5

Sat 10-4

Concrete & Plaster Primers


We have two types of epoxy primer for unfinished concrete or plaster surfaces. Bare plaster or concrete are highly absorbent materials which tend to soak up the first coat. Therefore, a primer should be used to soak in, seal the surface and provide a smoother profile for surfacing. These primers should only be used as a base coat for POXOLON 2 or ZERON. Do not use epoxy primers in conjunction with rubber-base coatings.







POXOPRIME II is an epoxy primer for application over uncoated concrete or plaster. Used as an undercoat for POXOLON 2 or ZERON, POXOPRIME II soaks in and seals the surface. POXOPRIME II's compatibility with wet surfaces helps reduce downtime by allowing the pool to be cleaned and primed in one day. Do not apply over any old coating.


Coverage: 200 - 250 square feet per gallon








GUNZITE is a two-part epoxy primer for application over fiberglass or unusually rough plaster or concrete. The heavy viscosity of GUNZITE acts as a fill coat on concrete and plaster and provides a much smoother surface, GUNZITE should only be used as an undercoat for POXOLON 2 or ZERON. Especially effective on sandblasted surfaces.


Coverage: 100 - 150 square feet per gallon


Metal Primer


Special care must be taken to insure the success of coating metal pool surfaces. Aluminum, steel and galvanized steel all have their special properties which require the selection of the appropriate primer. Bare metal should receive two coats of primer to eliminate pinholes and corrosion. Do not use the primer over an existing coating.







No. 219 STEEL PRIMER is for bare steel pool surfaces. Bare steel must be sandblasted, degreased and primed immediately. See label instructions for application.


Coverage: 200 - 250 square feet per gallon.


Poxoprime II  $64.99/gal

                         $28.99/qt.

Seals Surfaces

Reduces Downtime

Applies to Wet Surface


Gunzite   $67.99/gal

                 $29.99/qt.

For Rough Surfaces Applies Over Gunite Smooths Surface Profile


Steel Primer   $66.99/gal

Plain Steel Primer

Galvanized Steel Primer

Surface Sealer

Conversion Coating Fusion Plus





FUSION PLUS is the smart way to convert your worn rubber-base coated pool to an epoxy finish. Simply clean surface, roll on FUSION PLUS, then follow with one coat of ZERON or two coats of POXOLON. Your rubber–to–epoxy finish will be beautiful, and will last for years.

Coverage: Approximately 225 - 250 square feet per gallon

Fusion Plus $74.99/gal

Pool Paint Primers